Viewing And Editing Policy Configuration; Figure 58 Policy: Summary Table; Table 39 Policy: Summary Table - ZyXEL Communications GS-4012F/4024 User Manual

GS-4012F/4024 User's Guide
Table 38 Policy (continued)
LABEL
DiffServ
Outgoing
Metering
Out-of-profile
Action
Add
Cancel
Clear

19.3 Viewing and Editing Policy Configuration

To view a summary of the classifier configuration, scroll down to the summary table at the
bottom of the Policy screen. To change the settings of a rule, click a number in the Index field.

Figure 58 Policy: Summary Table

The following table describes the labels in this screen.

Table 39 Policy: Summary Table

LABEL
Index
Active
131
DESCRIPTION
Select No change to keep the TOS and/or DSCP fields in the packets.
Select Set the packet's TOS field to set the TOS field with the value you configure in
the TOS field.
Select Replace the IP TOS with the 802.1 priority value to replace the TOS field
with the value you configure in the Priority field.
Select Set the Diffserv Codepoint field in the frame to set the DSCP field with the
value you configure in the DSCP field.
Select Send the packet to the mirror port to sent the packet to the mirror port.
Select Send the packet to the egress port to send the packet to the egress port.
Select Send the matching frames (broadcast or DLF, multicast, marked for
dropping or to be sent to the CPU) to the egress port to send the broadcast,
multicast, DLF, marked-to-drop or CPU frames to the egress port.
Select Set the packet's VLANID to set the VLAN ID of the packet with the value you
configure in the VLANID field.
Select Enable to activate bandwidth limitation on the traffic flow(s) then set the actions
to be taken on out-of-profile packets.
Select the action(s) to be performed for out-of-profile traffic.
Select Drop the packet to discard the out-of-profile traffic.
Select Change the DSCP Value to replace the DSCP field with the value specified in
the Out-of-Profile DSCP field above.
Select Do not drop the matching frame previously marked for dropping to queue
the frames that are marked to be dropped.
Click Add to inset the entry to the summary table below.
Click Cancel to reset the fields back to your previous configuration.
Click Clear to set the above fields back to the factory defaults.
DESCRIPTION
This field displays the policy index number. Click an index number to edit the policy.
This field displays Yes when policy is activated and No when is it deactivated.
Chapter 19 Policy Rule