Nat Setup; Figure 12-4 Menu 11.3: Applying Nat To The Remote Node - ZyXEL Communications 10 User Manual

ZyWALL 10~100 Series Internet Security Gateway
Enter here to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.

Figure 12-4 Menu 11.3: Applying NAT to the Remote Node

The following table describes the options for Network Address Translation.
FIELD
Network When you select this option the SMT will use Address Mapping Set 1
Address (menu 15.1 - see section 12.3.1 for further discussion). You can
Translation configure any of the mapping types described in Table 12-2. Choose
Full Feature if you have multiple public WAN IP addresses for your
ZyWALL.
NAT is disabled when you select this option.
When you select this option the SMT will use Address Mapping Set
255 (menu 15.1 - see section 12.3.1). Choose SUA Only if you have
just one public WAN IP address for your ZyWALL.

12.3 NAT Setup

Use the address mapping sets menus and submenus to create the mapping table used to assign global
addresses to computers on the LAN and the DMZ. You can see two NAT address mapping sets in menu
15.1. You can only configure Set 1. Set 255 is used for SUA. When you select Full Feature in menu 4 or
12-8
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
IP Address= N/A
IP Subnet Mask= N/A
Gateway IP Addr= N/A
Network Address Translation= Full Feature
Metric= N/A
Private= N/A
RIP Direction= None
Version= N/A
Multicast= None
Table 12-3 Applying NAT in Menus 4 & 11.3
DESCRIPTION OPTIONS
Full Feature
None
SUA Only
NAT