Table of Contents
Advertisement
Problem
I cannot change the fan
speed.
The remote control does
not work.
The Timed on/off function
does not work.
The indicator blinks
continuously.
Odours permeate in the
room during operation.
An error is indicated.
Noise is generated.
Smoke is generated from
the outdoor unit.
Water drops from the pipe
connections of the outdoor
unit.
DB68-06031A-01_A5.indd 25
• When the Auto, Dry, or Fast mode is running or the good'sleep function
is running in the Cool mode, the air conditioner controls the fan speed
automatically and you cannot change the fan speed.
• Replace the batteries in the remote control with new ones.
• Make sure that nothing is blocking the remote control sensor.
• Check whether there are strong lighting apparatus near the air
conditioner. Strong light which comes from fluorescent bulbs or neon
signs may interrupt the electric waves.
• Check whether you pressed the SET button on the remote control after
setting the time.
• Press the Power button to turn off the air conditioner or disconnect the
power plug. If the indicator is still blinking, contact the service centre.
• Check whether the air conditioner is running in a smoky area. Ventilate
the room or operate the air conditioner in the Fan mode for 3 to 4 hours.
(There are no components used in the air conditioner that emit a strong
odour.)
• Check whether the drains are clean. Clean them regularly.
• If the indoor unit indicator blinks, contact the nearest service centre. Be
sure to pass the error code to the service centre.
• When refrigerant flow changes, noise may be generated, depending on
the status of the air conditioner. This is a normal operation.
• If may not be a fire but it can be a steam generated from the outdoor
heat exchanger while the defrost function is running in the Heat mode
in winter.
• Condensation may develop when the ambient temperature changes
excessively. This is a normal operation.
Solution
English
25
4/18/2017 8:59:34 AM
Advertisement
Table of Contents
