DFI G586OPA User Manual page 73

Installing the Windows 3.1x and Windows for
Workgroups Driver
To install:
1. You must first install the DOS driver. (Run
INSTALL.EXE, under the DOSDRV directory, to
install the DOS driver).
2. Use Windows File Manager to run
A:\WINDRV\INSTALL.EXE.
To remove:
1. When you install the Windows driver, the original
SYSTEM.INI under the Windows directory will be
renamed as SYSTEM.001.
To remove the installed Windows driver, rename
SYSTEM.001 to SYSTEM.INI.
The Windows 32-bit driver supports:
1. Two channels with two drives for each channel. This
totals to a maximum of four drives.
2. Track Remapping to support hard disk larger than
528MB.
3. Microsoft' s 32-bit driver does not support a second-
ary channel and track remapping. It also does not
enable the 32-bit disk access during installation if
the target disk is connected to the secondary chan-
nel. The 32-bit disk access will be enabled after the
Windows driver is installed.
G586OPA
IDE Device Drivers u 4-6