Yamaha powered mixer Owner's Manual page 16

14
Front and rear panel
4
Foot switch jack (FOOT SW)
A separately sold Yamaha FC5 foot switch can be
connected to this jack. If a foot switch is con-
nected to this jack, you can use your foot to
switch the built-in digital effect on/off.
5
AUX IN/2TR IN—INPUT TO MAIN jacks
These are input jacks that allow the signal from
an external device to be added to the MAIN out-
put. Monaural output devices such as external
effects can be connected to the AUX IN jack, and
stereo output devices such as cassette recorder or
CD players can be connected to the 2TR IN jacks.
The nominal input level and impedance are –10 dB/
600 for the AUX IN jack, and –10 dBV/600 for
the 2TR IN jacks.
6
REC OUT/MAIN/MONITOR—OUTPUT jacks
These are output jacks which send line level sig-
nals from the EMX66M to external devices.
A stereo recording device such as a cassette deck,
DAT or MD recorder can be connected to the
REC OUT jacks, and a playback device such a
power amp can be connected to the MONITOR
and MAIN jacks. The signals sent from each jack
are as follows.
• REC OUT jacks: The MAIN bus signal before it
has passed through the MASTER control and
graphic equalizer
• MAIN jack: The MAIN bus signal which has
passed through the Main MASTER control and
graphic equalizer
• MONITOR jack: The MONITOR bus signal
which has passed through the Monitor MAS-
TER control and graphic equalizer
The nominal output level and impedance are
–10 dBV/10 k for the REC OUT jacks, and
+4 dB/10 k for the MONITOR/MAIN jacks.
EMX66M—Owner's Manual