Advertisement
4.0 Bench Mounted or Installed into a Panel (cont.)
4.2 Panel Mounting
- Ensure that there is sufficient space behind the relevant instrument panel for the SI3500 and its cabling (refer to section 4.3 for dimensions).
- Cut out the panel aperture to the dimensions shown.
- Working from behind the panel, with the box fully located, fit the side brackets to the studs and slide them forward toward the panel until they lock into
place.
- Screw the brackets to the panel.
CAUTION: Do not over tighten the screws as this may damage the case of the instrument.
WARNING: On installing or removing the SI3500, you must be aware of any hazardous equipment or materials in the vicinity. Make sure that any
equipment into which the SI3500 system is to be installed is switched off and made safe.
CAUTION: Avoid installing the SI3500 close to switch gear, contactors or motor starters.
CAUTION: Do not place other signal and power supply wiring in the same loom as the SI3500 wiring.
CAUTION: Use screened cables for all leads, with the screen earthed at one end only.
CAUTION: Do not plug probes into the unit when it is switched on.
4.0 Bench Mounted or Installed into a Panel (cont.)
6
502783 issue 5
Advertisement
