Advertisement
5.0 Display Panel (cont.)
5.3 Overview of Features
Transducers
1 or 2 transducers may be connected
SI3100 Series LVDT
(Note: when setting up LVDT enter sensitivity in mV/V/mm regardless of final choice of measurement units)
SI3300 Series 4-20 mA or DC inputs (0-5 V, 0-10 V, ±5 V, ±10 V)
SI3500 Series – Orbit (Digital Probes and Linear Encoders)
Measurements
The SI3000 series can display in single measurement mode A, B, A+B, A-B, (A+B)/2, (A-B)/2 and (B-A)/a
and Display
The SI3300 and SI3500 series can display in dual measurement mode the sensor information A and B only; it is not possible to
display any combinational information in dual display mode.
(Note: (B-A)/a limited to ±2.5 deg.)
Limits
Upper and lower limits are set for each individual measurement channel (A and B) and for a combinational measurement (e.g. A+B)
The SI3000 series has 6 isolated open collector limit outputs which are allocated in accordance to the measurement mode.
A
B
A+B etc
If the measurement is within limit, then the good limit output is set, otherwise the upper or lower limit outputs are set to indicate a
reading out of limit.
5.0 Display Panel (cont.)
Lower
Good
Active
Active
Off
Off
Active
Active
11
Upper
Lower
Active
Off
Off
Active
Active
Active
Good
Upper
Off
Off
Active
Active
Active
Active
502783 issue 5
Advertisement
