Advertisement
5.0 Display Panel (cont.)
5.3 Overview of Features (cont.)
Functions
The SI3000 series has the following functions available from the font panel keypad or controllable from the RS232 and some discrete
inputs.
Zero: Allows a reading to be set to zero (display shows TARE) all measurements are then referenced to the zero position.
Print: Allows measured data to be printed via the RS232 port.
Peak/Track Allows the readout to be switched from track mode to peak+ or peak-. In peak mode the displayed value will only change
if it is greater than (peak+) or less than (peak-) the current displayed value.
Menu (keypad only) accesses menu screens for set up.
The SI3300 and SI3500 series have the following additional functions:
Preset: Allows a preset value to be added to the displayed reading only – does not change the analogue outputs. Enable preset from
the preset menu and activate with the up arrow key.
In dual display mode it is possible to set the preset and zero to activate on both channels
Log Mode: The readout can log and store data in three modes
Normal logging which will store a number of readings at a predefined interval. Setup and start from logging menu screen
Trigger start which will store a number of readings at a predefined interval, once the start logging input is triggered.
Log on Trigger which will store a reading every time the logging input is triggered, this mode is started from the logging menu.
Inputs
6 discrete inputs, Zero, Change from track to peak+ to peak-, print, log, real reset, preset
Analogue Outputs
Dual Display (SI3500 and SI3300 only)
Each analogue output can be independently set for 4-20 mA or a DC voltage (0-5 V, 0-10 V, ±5 V and ±10 V
5.0 Display Panel (cont.)
A
B
A+B etc.
Analogue Output 1
A
Off (null)
A+B etc.
A
12
Analogue Output 2
Off (null)
B
A+B etc.
B
502783 issue 5
Advertisement
