General Instructions For Gasburners - Bentone BG 550 Installation And Maintenance Instruction

11. General instructions for gasburners

11.3.1 Installation
1. Follow standards and instructions applicable to the
installation of gas burners
2. Ensure that the electric installation is made in accordance
with existing regulations
3. Check that the fresh air intake of the boiler room is
sufficiently dimensioned
4. Check by studying the data plate that the efficiency of the
burner is adapted to the boiler output
11.3.2 Maintenance
General instructions
1. Keep the boiler room clean
2. Ensure that the fresh air intake of the boiler room is not
restricted
3. Switch off the current and shut off the gas supply if the
burner must be withdrawn from the boiler
4. Do not use the boiler for burning paper and waste if there
is no special arrangement ( fire room ) for this
11.3.3 If the burner has stopped
1. Press the reset button of the relay
2. Check that the max. thermostat has not cut out
3. Check other thermostats for example room ther mostat,
if any
4. Check that the gas pressure to the burner is sufficient
5. Check that the electric fuses have not blown
6. Make a new attempt to start the burner and check the
counter of the gas meter to find out whether the solenoid
valve opens
7. If the burner does not start in spite of repeated starting
attempts call the installer
5. Check that the burner is adapted to the gas quality in
question
6. Check that the input pressure of the gas is correct
7. Check that the dampers of the boiler are open
8. Check that there is water in the system
9. Check that thermostats etc. are correctly adjusted
10. Read the instructions and follow the directions given for
the burner as to starting-up and service
Normal operation
1. Ensure that the air supply to the burner is not obstructed
by dust and dirt
2. Have the installer make a yearly overhaul of the installation
so that safety is not jeopardized
3. Have the installer at the yearly overhaul also adjust the
burner to ensure optimal combustion economy
4. Check periodically that there is water in the system ( fill
up if necessary ) and that thermostats etc. are normally
adjusted
5. Ensure that there is no water or dampness in contact with
the burner
11.3.4 Shut-Off
1. Switch off the current with the main switch
2. Shut-off the gas supply with the shut-off cock on the
burner
11.3.5 Warning
1. Never keep your face in front of the fire room door when
starting up the burner
2. Do not use naked flame when inspecting the fire room
Authorized installer::
Address:
Telephone:
172 615 07 2018-01-04