Back Panel - Tenda D302 User Manual

Solid
Blinking
WPS
Off

Back Panel

ON/OFF: Power switch to turn the router on or off.
_________________________________________________________________________________________________
Note:
Please use the included power adapter. Use of a power adapter with different voltage rating may damage the device.
_________________________________________________________________________________________________
WPS/RESET: Press it for 1-3 seconds to enable WPS connection or 7 seconds to restore all configurations to
factory defaults.
LAN: Ethernet RJ-45 LAN ports to cable the device to the local network devices such as computers.LAN:
Ethernet RJ-45 LAN ports to cable the device to the local network devices such as computers.
DSL: RJ-11 Asynchronous DSL (ADSL) port for connecting the device to a DSL line.
Follow the diagram below to install the device.
Client connected successfully.
The WPS LED starts blinking if you pressed the WPS button on the
device or interface.
If there is no wireless clients connected, the WPS LED turns off after
blinking for 2 minutes.
- 9 -
Wireless Modem Router User Guide