Table of Contents
Advertisement
IPoE
(If your ISP uses DHCP to assign
your IP address or if your ISP assigns
you a static (fixed) IP address, IP
subnet mask and the gateway IP
address, you need to select the IP
over Ethernet (IPoE).
IPoA
Bridging
_________________________________________________________________________________________________
Tip:
For PPPoE, IPoE, and Bridging Internet connection types, you must first select EoA on the ATM Interface Screen, for
more information, see
To set up the ATM
_________________________________________________________________________________________________
PPP over Ethernet (PPPoE)
If you have selected the EoA from the ATM Interface screen in Layer2 Interface, you will see the screen below when
you click the WAN Service tab, select the configured interface and click Next.
Dynamic IP
No entries are needed.
Static (Fixed) IP
Enter the assigned IP address, subnet mask, and the
IP address of your ISP's primary DNS server. This
information should have been provided to you by
your ISP. If a secondary DNS server address is
available, enter it also.
Static (Fixed) IP
Enter the assigned IP address, subnet mask, and the
IP address of your ISP's primary DNS server. This
information should have been provided to you by
your ISP. If a secondary DNS server address is
available, enter it also.
If you wish to iniate a dialup directly from your PC
for Internet access or enjoy the entire Internet
connection (instead of sharing it with others), you
can select the Bridging and then click Next.
interface.
- 22 -
Wireless Modem Router User Guide
Advertisement
Table of Contents
