Ap Client Mode; Lan Setup - Tenda W302A User Manual

Note
In WDS mode, both the AP and the remote device should support WDS feature and you should keep their
SSIDs, channels, security modes and keys the same. As for IP addresses, they should not be the same but
on the same network segment.

3.3.3 AP Client Mode

In this mode, the AP negotiates with the remote device successfully and also provides access to clients. The
device's SSID won't be changed. Click Quick Setup and select AP Client Mode to enter screen below:
Configuration Procedures:
1. Click Enable Scan;
2. Select the remote SSID you wish to connect;
3. Configure the security settings, including security mode, cipher type and security key. These settings
should be kept the same as the remote device's;
4. Click Save.
Note
After finishing settings on Quick Setup interface, please refer to
to set your PC to Obtain an IP address automatically, and then you can surf the Internet.

3.4 LAN Setup

Click LAN Setup and here you can configure address mode, the LAN IP address and subnet mask.
Appendix---1. Configure PC TCP/IP Settings
18
300M Wireless AP