Wds Mode - Tenda W302A User Manual

2. Security Mode: Configure the security mode (WPA-PSK is recommended);
3. Cipher Type: Select a cipher type according to your need (AES is recommended);
4. Security Key: Configure a security key;
5. Click Save.

3.3.2 WDS Mode

In this mode, this device can provide access to at most 4 APs. Click Quick Setup and select WDS Mode to
enter screen below:
Configuration Procedures:
1. Click Enable Scan;
2. Select the remote SSID you wish to connect;
3. Configure the security settings, including security mode, cipher type and security key. These settings
should be kept the same as the remote device's;
4. Click Save.
5. Log in to the remote device's Web interface and follow steps 1-4 as shown above to configure the same
settings on it.
When bridged successfully, Status displays "Connected" next to the corresponding MAC Address field.
17
300M Wireless AP