Download Print this page

Section 5: Technical Support - Elo TouchSystems ET1903LM User Manual

Hide thumbs Also See for ET1903LM:

Advertisement

Section 5: Technical Support

If you are experiencing trouble with your touch monitor, refer to the following suggestions.
If the problem persists, please contact your local dealer or contact Elo Touch Solutions Customer Service. Worldwide technical support phone numbers
are available on the last page of this user manual.
Solutions to Common Problems
Problem
The touch monitor does not respond when turning on
the system.
Monitor display is dim.
Monitor display is blank.
Monitor displays the "Out of Range" message.
Monitor display image looks strange.
Touch functionality doesn't work.
Neither the OSD nor power buttons
responds when pressed.
No touch, or touch is not accurate when using
privacy filters.
Monitor turns off by itself.
User Manual ET1903LM, ET2203LM, ET2403LM, ET2703LM REVB
Suggested Troubleshooting
Check that the DC power adaptor is properly connected. Verify the
DC power adaptor is functioning
Use the OSD to increase the brightness.
Use the OSD to increase the contrast.
If the Power Status LED is blinking, the monitor or Computer Module may be in SLEEP mode. Press
any key/move the mouse/touch the touchscreen to see if the image reappears. Check that the signal
source device is turned on.
Check that that there are no loose cable connections.
Adjust your computer's resolution/timing mode to be within the allowable timing ranges
specified for your touch monitor (see website for specifications).
Adjust your computer's resolution/timing mode to be within the allowable timing ranges
specified for your touch monitor (see website for specifications).
Use the Auto Adjust function in the OSD.
Verify your PC has the latest Elo drivers installed.
Perform the calibration routine provided with the latest Elo drivers.
Check to see if the OSD lock or power lock functions are on.
Check if the touch-through mode is enabled for 19"/22" monitors.
If the monitor turns off by itself, it could be due to a voltage drop (to below 10 V) in the building. The
monitor will turn itself back on once it receives minimum 11 V of power.
20

Advertisement

loading

This manual is also suitable for:

Et2203lmEt2403lmEt2703lm