Advertisement
Section 5: Technical Support
If you are experiencing trouble with your touch monitor, refer to the following suggestions.
If the problem persists, please contact your local dealer or contact Elo Touch Solutions Customer Service. Worldwide technical support phone numbers
are available on the last page of this user manual.
Solutions to Common Problems
Problem
The touch monitor does not respond when turning on
the system.
Monitor display is dim.
Monitor display is blank.
Monitor displays the "Out of Range" message.
Monitor display image looks strange.
Touch functionality doesn't work.
Neither the OSD nor power buttons
responds when pressed.
User Manual ET1302L
Suggested Troubleshooting
Check that the DC power adaptor is properly connected. Verify the
DC power adaptor is functioning
Please purchase the approved power source that is certified by an
IEC or UL through the specified dealer.
Use the OSD to increase the brightness.
Use the OSD to increase the contrast.
If the Power Status LED is blinking, the monitor or Computer Module may be in SLEEP mode. Press
any key/move the mouse/touch the touchscreen to see if the image reappears. Check that the signal
source device is turned on.
Check that that there are no loose cable connections.
Adjust your computer's resolution/timing mode to be within the allowable timing ranges
specified for your touch monitor (see website for specifications).
Adjust your computer's resolution/timing mode to be within the allowable timing ranges
specified for your touch monitor (see website for specifications).
Use the Auto Adjust function in the OSD.
Verify your PC has the latest Elo drivers installed.
Perform the calibration routine provided with the latest Elo drivers.
Check to see if the OSD lock or power lock functions are on.
15
Advertisement
