Technics SX-KN2400 Operating Instructions Manual page 96

Part IV
Example: 10.2.48 indicates a point in measure
10, beat 2, point 48 (one point is 1/96 of a
quarter note [ ]).
q
• is shown at the point where the END com-
mand is stored.
7.
Select the data to edit (it changes to a long
bar). Edit the data.
• Use the POS L and M buttons to move the
∧
cursor, the SND and
the percussion instrument sound, and the VEL
∧ ∨
and buttons to change the velocity (how
hard the keys are played).
• If the ERS button is pressed, the selected
NOTE data is erased.
8.
Repeat steps 4 to 7 to continue editing.
96
QQTG0692
∨
buttons to change
Inserting DRUMS data
You can also store DRUMS data on this display.
1.
Specify the point where the new note data will
be stored.
∧ ∨
2.
Use the VEL and
velocity (how hard the key is played).
3.
Press the ENTER button to store the data.
• Instead of the ENTER button, you can store
data (including velocity data) by playing the
keyboard. In this case, the instrument is that
specified on the display, regardless of which
key is played.
4.
Repeat steps 1 to 3 to input more DRUMS
data.
CYCLE PLAY
You can aurally check the data you are editing by
accessing the CYCLE PLAY display from the
DRUM EDIT display.
• The procedure is the same as for NOTE EDIT.
• If you wish other tracks to be played back,
they should be selected beforehand on the
SEQUENCER PLAY display. (Refer to page
81.)
Sequencer
buttons to specify the