Loading Data - Technics SX-KN2400 Operating Instructions Manual

Part VII

Loading data

Load the data from the SD card to this instrument's memories.
• Note that the load procedure causes any data which is currently stored in the relevant memories to be
erased.
SD LOAD
Load data that saved to a card into this instru-
ment's memory.
1.
Insert the SD card with the stored data into the
SD slot. (See page 131.)
• Close the lid securely.
2.
Press the SD button to turn it on.
S D
LOAD
3.
On the SD MENU display, select LOAD.
• The display looks similar to the following.
• If there are only SMF files on the card, the dis-
play automatically changes to the SD-SOUND
(SMF) LOAD display.
FOLDER
1.
Use the buttons below the display to select the
SONG you wish to load.
• Select the folder name first, and then select
the SONG name.
• Press the PREV button for the previous page
and the NEXT button for the next page.
SD IN USE
4.
Use the buttons to the right of the display to
select the type of loading.
FOLDER:
Select files to load from a list of all folders and
of saved songs in each folder.
ALPHABET (See page 134.)
Select files to load from an alphabetical list of
all songs.
NUMBER (See page 134.)
Select files to load specifying folder and song
numbers.
• The priority that sets which display is shown
first can be set at the SD PREFERENCES dis-
play. (Refer to page 145.)
2.
Press the LOAD button.
• The LOAD operation begins.
• When the operation has been successfully
completed, "COMPLETED!" is shown on the
display.
• If song data was loaded, you can press the
START/STOP button to begin playback when
the SEQUENCER PLAY display is active.
• You can load the type of data for which only
one song can be recorded in the SEQUEN-
CER. (This type is available for cards used
with older Technics models.) Note, however,
that in this case, the song is loaded into
SONG 1, but the data in SONG memories 2 to
10 are erased.
• You can also access the LOAD display by
pressing the SD button for a few seconds.
SD Card (KN2600)
133
QQTG0692