Advertisement
ASSEMBLY INSTRUCTIONS
Attach the pan support (Figure 1 [6]) to the housing cover using two 10-32 pan head screws. The PTO
adapter (Figure 2) should remain on the PTO drive shaft when the grinding head is removed. The com-
ponents of the grinder assembly should be washed with a warm water and mild soap solution and dried
prior to use. Inspect the knife (Figure 4 [6]) for sharpness and handle it with care.
Remove the PTO cover cap. Insert the grinder housing (Figure 4 [4]) into the PTO hub of the drive
unit. Align the pin in the grinder housing with the hole in the PTO hub and push the grinding head fully
into the PTO. Tighten the thumb screw to secure the grinder head to the PTO.
Lightly coat the drive shaft and fiber washer of the worm assembly with Petrol-Gel. Insert the worm
assembly into the grinder housing aligning the square shaft end with the PTO adapter and fully engaging
it in the PTO adapter.
The knife (Figure 4 [6]) and grinder plate (Figure 4 [7]) should be coated with Petrol-Gel or beef
tallow prior to assembly. Place the knife, sharp edges facing out, on the square extension of the worm
assembly. Place the grinder plate on the pin in the end of the worm and into the grinder housing aligning
the notch in the plate with the pin in the grinder housing. Screw the ring (Figure 4 [8]) onto the grinder
housing using only minimum force. The ring controls the pressure between the plate and the knife. The
knife is easily damaged by running dry or excessive force on the ring.
Insert the spout on the feed pan into the throat of the grinder and rest the pan on the pan support
bracket on the drive unit.
Page 5
Advertisement
