Installation; Assembly And Operating Instructions - Univex MG0012 Operator's Manual

• This is a table-top unit.
• Insure that the grinder is located on a flat, level and stable surface. There should be sufficient
clearance around the grinder for safety and ease of operation. Sufficient space must be provided
for the feed pan and the collection container.
ASSEMBLY:
WARNING: DISCONNECT THE ELECTRICAL POWER SUPPLY CORD PRIOR TO ASSEMBLY.
1. Mount the grinder housing to the power drive unit by inserting the grinder into the opening in the
drive with the flat on the grinder housing facing up. Push the grinder housing in all the way to
align the groove in the grinder housing with the pin in the drive housing and rotate the grinder
counter clockwise until ti stops in the with the grinder throat vertical.
2. Slide the worm assembly into the grinder housing and rotate it until the slot at the rear of the
worm engages the drive shaft and seats fully on the drive shaft.
3. Slide the knife, with the sharp edges outward toward the plate, onto the square on the worm.
WARNING: The knife is very sharp and can cut fingers.
4. Slide the appropriate plate onto the worm and and into the grinder housing aligning the slot in the
plate with the pin in the grinder housing
5. Screw the ring onto the grinder housing until it is just snug. Too much pressure on the ring can
damage the grinder.
6. Insert the spigot on the feed pan onto the throat of the grinder housing.
7. Place a suitable container under the grinder discharge to receive the ground product.
WARNING: NEVER put fingers or utensils into the throat of the grinder or the knife and plate.
PROCESS:
1. Cut meat or other products to be processed to fit into the grinder. Place the product in the feed
pan.
2. Connect the electrical power supply cord and turn the power switch on.
2. With the grinder running, use the meat stomper to guide the product into the grinder.
3. Collect the ground product in a suitable container.

INSTALLATION

ASSEMBLY AND OPERATING INSTRUCTIONS

Page 5