Advertisement
SAFETY IS OUR TOP PRIORITY
READ AND MAKE SURE THAT YOU UNDERSTAND THE INSTRUCTIONS AND SAFETY
WARNINGS IN THIS BOOKLET BEFORE ATTEMPTING TO OPERATE THIS MEAT GRINDER.
NEVER PUT FINGERS OR HANDS IN THE THROAT OF THE GRINDER WHILE THE GRINDER IS
OPERATING OR SERIOUS INJURY WILL RESULT.
NEVER ATTEMPT TO CLEAR JAMMED PRODUCT WITHOUT SHUTTING THE POWER OFF AND
DISCONNECTING THE ELECTRICAL POWER SUPPLY CORD.
IT IS A VIOLATION OF UNITED STATES DEPARTMENT OF LABOR REGULATIONS TO PERMIT
OPERATION OF THIS UNIT BY ANY PERSON UNDER THE AGE OF 18 YEARS.
SWITCH THE POWER "OFF" BEFORE CONNECTING THE UNIT TO THE POWER SOURCE, OR
RESETTING THE CIRCUIT BREAKER. MAKE SURE THE SWITCH IS IN THE "OFF" POSITION,
OR THE MACHINE WILL START WHEN THE ELECTRICAL POWER IS RESTORED.
A MANUAL RESETTABLE OVERLOAD CIRCUIT BREAKER IS PROVIDED ON THE BACK OF
THE MACHINE. IF THE CIRCUIT BREAKER IS TRIPPED, SWITCH THE POWER "OFF", DISCON-
NECT THE ELECTRICAL POWER SUPPLY CORD, DETERMINE AND CORRECT THE FAULT AND
RESET THE BREAKER.
WHEN THE UNIT IS NOT IN USE, PLACE THE ON/OFF SWITCH IN THE "OFF" POSITION AND
REMOVE THE SWITCH KEY BY PINCHING THE KEY BETWEEN THE THUMB AND FOREFIN-
GER AND PULLING IT FROM THE SWITCH. REMOVING THE KEY WILL PREVENT THE SWITCH
FROM BEING SET TO THE "ON" POSITION.
ASSURE THAT THE MEAT CHOPPER IS PROPERLY ASSEMBLED AND INSTALLED WITH THE
THUMB SCREW TIGHTENED BEFORE CONNECTING THE ELECTRICAL SUPPLY.
THE KNIFE IS SHARP. USE EXTREME CARE WHEN HANDLING OR CLEANING IT.
DO NOT PUT YOUR FINGERS INTO THE THROAT OF THE GRINDER WHEN THE ELECTRICAL
POWER SUPPLY IS CONNECTED. USE THE STOMPER TO PUSH MEAT INTO THE GRINDER
THROAT.
DO NOT PUT FINGERS OR OBJECTS INTO THE HOLES IN THE PLATES.
WIPE DOWN THE EXTERIOR OF THE DRIVE UNIT ONLY, NEVER HOSE DOWN OR IMMERSE
THE DRIVE UNIT IN WATER.
DO NOT ATTEMPT TO SERVICE THE DRIVE ASSEMBLY. PLEASE CONTACT UNIVEX
CORPORATION FOR THE NUMBER OF THE NEAREST AUTHORIZED SERVICE AGENT IN YOUR
AREA FOR ADJUSTMENTS OR REPAIR.
Page 3
Advertisement
