Table of Contents
Advertisement
13> A Disable/Enable menu appears. Select "Enable" and press <Enter>.
Set Boot from SAN
Disable
Enable
14> Confirm that the setting of "Set Boot from SAN" is [Enable].
001: LPe12002-M8-N PCIe2.5Gb/s , x8
LPe12002-M8-N Node Name : 20000090FA211128
Seg#: 000 Bus#: 40 Dev#: 00 Func#: 00
RECONNECT DEVICES
Set Boot from SAN [Enable]
▶ Scan for Fibre Devices
▶ Add Boot Devices
▶ Delete Boot Device
▶ Change Boot Device Order
▶ Configure HBA and Boot Parameters
▶ Set Emulex Adapter to Default Settings
▶ Display Adapter Info
15> If any other ports of this product are connected to the Fibre Channel boot device, Press <Esc> key
to return to the adapter list and setting ports by the same steps from 5>.
16> Now, you have made settings to start installing an operating system on your Fibre Channel device.
Save changes and exit the STEUP utility of the computer, and start installation.
- 76 -
Advertisement
Table of Contents
