Table of Contents
Advertisement
11> Select "Boot this device via WWPN".
Confirm that the top item on the list is "Used".
01: LPe12002-M8-N : Bus#: 60 Dev#: 00 Func#: 01
Mem Base: E7980000 Firmware Version : US2.01A12 Boot BIOS: Disabled!
Port Name: 10000090FA21128 Node Name: 20000090FA21128
Topology: Auto Topology: Loop First (Default)
1. Used DID:000000 WWPN:21000016 97122446 LUN:00 Primary Boot
2. Unused DID:000000 WWPN:00000000 00000000 LUN:00
3. Unused DID:000000 WWPN:00000000 00000000 LUN:00
4. Unused DID:000000 WWPN:00000000 00000000 LUN:00
5. Unused DID:000000 WWPN:00000000 00000000 LUN:00
6. Unused DID:000000 WWPN:00000000 00000000 LUN:00
7. Unused DID:000000 WWPN:00000000 00000000 LUN:00
8. Unused DID:000000 WWPN:00000000 00000000 LUN:00
12> Press <Esc> key to return to the menu like:
01: LPe12002-M8-N : Bus#: 60 Dev#: 00 Func#: 01
Mem Base: E7980000 Firmware Version : US2.01A12 Boot BIOS: Disabled!
Port Name: 10000090FA21128 Node Name: 20000090FA21128
Topology: Auto Topology: Loop First (Default)
Emulex LightPulse FC BIOS Utility. UB2.12a15
List of saved Boot Devices:
<↑/↓> to Highlight, <Enter> to Select
Copyright (c) 1997-2014 Emulex. All rights reserved.
Emulex LightPulse FC BIOS Utility. UB2.12a15
Enable/Disable Boot from SAN
Scan for Target Devices
Reset Adapter Defaults
Configure Boot Devices
Configure Advanced Adapter Parameters
Enter ＜Esc> to Previous Menu
<↑/↓> to Highlight, <Enter> to Select
Copyright (c) 1997-2014 Emulex. All rights reserved.
Then, you see Boot device's settings window again.
- 70 -
Advertisement
Table of Contents
