NEC NE3390-160 User Manual page 56

(1) PCI Express connector
Connector to be inserted into the PCI slot of the computer.

Tips
(2) Bracket
Bracket to fix this product to the extended slot of Computer.

Tips
(3) SFP+ Module
Module to transmit and receive Fibre Channel signals. Need to remove temporarily when exchange a
bracket or install this product into computer.

Notice
(4) LED (Port0/Port1)
Two LED for each port (Port0/Port1) give a visual indication of the operating state.
The slow blink rate is 1Hz; the flashing state is an irregular on/off appearance reflecting program
activity.
Green LED
Off
Off
Off
Off
On
On
On
On
Slow Blink
 If the product fails at POST, please check the following items.
Notice
(5) Fibre Channel Connector (Port0/Port1)
Connector (LC Connector) used to connect this product to a Fibre Channel device.
Do not remove dust cover when not connected to Fibre Channel device.
(6)IEEE Address (Port0/Port1)
IEEE Address is displayed by this label.

Tips
This product's PCI Express connector type is x8.
When fixing this product to a PCI slot optimized for the low profile type, replace the
bracket with the attached low profile one.
Don't insert the SFP+ module of this product to the other NE3390-160 or the other
Fibre Channel device.
Yellow LED
Off Boot Failure (Dead Board)
On POST Failure (Dead Board)
Slow Blink Boot Failure after POST
Flashing POST Processing in Progress
Off Failure While Functioning
On Failure While Functioning
4Gbps Link Rate – Normal, link up
Blink(3 beat)
8Gbps Link Rate – Normal, link up
Blink(4 beat)
Normal – Link Down
Off
- Is the product installed in the computer correctly?
- Are all Fibre Channel cables and power cords connected correctly?
The IEEE address correspond to the lower 12 figures of Worldwide Name(WWN)
address.
State
- 54 -