Impecca IPAH-12K User Manual page 10

InsTAllATIon In A slIDInG sAsH WInDoW:
1 . Cut the foam seal(adhesive type) to the proper length and attach it to the window frame . (see Figure R)
2 . Attach the window slider kit to the window stool . Adjust the length of the window slider kit according to
the width of window, shorten the adjustable window kit if the width of window is less than 26 .5 (Type I)
or 22 .1 (Type II) inches . Open the window sash and place the window slider kit on the window stool .
(see Figure S)
3 . Cut the foam seal (adhesive type) to the proper length
and attach it on the top of the window . (see Figure T)
4 . Close the sliding sash securely against the window .
5 . Cut the foam seal to an appropriate length and sea the open gap between the top window sash and
outer window sash . (see Figure U)
FRonT PAnel oveRvIeW:
The following diagram and legend shows the functions of the front operating panel . Some functions are
only available on select models .
1) Power Function
2) sleep button
3) Fan/Ion* button
Control fan speed between low, medium, high and auto.
Press and hold for 3 seconds to enable/disable the ion air
purification feature.
4) Up (+) and Down (–) buttons
Use to increase or decrease temperature. To change between
degree display in F or C, press and hold both + and – buttons
simultaneously for 3 seconds.
5) Mode selector button
Alternate between Auto, Cool, Dry, Fan & Heat modes
6) Timer button
Activate the unit for a set period of time, increased and
decreased using the + and – buttons
7) swing button
Activate the swing feature and/or stop the directional blade in
its position manually.
8) leD display
Displays the set temp., in fan/dry mode displays actual temp.
8
9) Follow Me indicator light*
Function activated via remote control ONLY–Follow Me
functionality is only available on select units.