Using The Screen; Battery And Charger - URBANGLIDE RIDE 85XL Original Manual

Using the screen

1. To start the scooter press the On/Off button for 1 second and to turn it off press the
On/Off button for 3 seconds.
2. Press the On/Off button twice to change the speed mode from speed 1 to 3.
3. Squeeze the throttle trigger to control your speed from 1 to 25 km/h.
4. To brake, squeeze the brake trigger.
5. Press the On/Off button once with the scooter turned on to turn the headlamp on or
off.
6. In case of emergency: Press the rear mudguard to allow the scooter to stop rapidly.
7. After riding at a constant speed for a while, the cruising speed will be set
automatically. The speed will be constant without touching the accelerator.

Battery and charger

Battery
Before using for the first time, please fully charge the battery. The battery can be
charged at any time and will not be damaged by frequent charging. In the meantime, do
not forget to charge it every 3 months if you do not use it for a long time.
Charger
The charger with self-protection function must be switched off when the battery is 100%
full. Charging time is 3-4 hours. The warranty will not cover repairs if the battery is
damaged due to abnormal use.
Charging Instructions
1. Open the rubber end cap and insert the plug into the hole.
2. Plug the other end into an electrical outlet.
3. When the indicator light is red, this shows that charging is in progress. When the
indicator light is green, it shows that the charging is complete and finished
7