Using The Screen; Advanced Setting - URBANGLIDE RIDE 80 BOOST Translation Of The Original Instructions

1
Trigger of acceleration: Squeeze the trigger to advance
2
Electronic Brake Trigger: Pressing the trigger to brake, the more you press, the harder you will brake.
3
Horn: Turn on your scooter and press this button to beep.
Setting: There are 3 modes, "total", "trip" and "time". Press this button to change it. If you wish to reset trip mode, press
4
this button for 3 sec.
5
On / off button: Press this button to turn your device on or off.
6
Light: Press this button to turn on or off your light. Remember to turn it off if you do not need it.
7
Display screen
8
Speed: There are three speed modes 1/2/3, you can change speed with this button.
•
Two start modes:
•
The first original mode allows you to accelerate directly when the scooter is stopped.
•
After giving a push to the ground with your foot, the second mode accelerates when the scooter is
moving,.
To change this option, simply go to the advanced settings, press button 3 and 4 at the same time for 3sec.
In the menu, press "set" once, advanced option # 1 will display on the large screen. A number appears at the
bottom right of the screen, you can change it by pressing the speed button. The 0 corresponds to the first start
type, the 1 to the second start type.

Using the screen

Advanced setting

7