Start Embroidering - Brother 882-D80 Operation Manual

CREATING BOBBIN WORK

Start Embroidering

a
Hoop the fabric so the right side of the
fabric is facing down with the stabilizer
lying on the top. Use an embroidery frame
that fits the size of the pattern and then
attach the frame to the machine. These
patterns are embroidered from the wrong
side of the fabric so technically you are
working in "reverse" of normal
embroidering.
a Wrong side of fabric
CAUTION
• Always use a stabilizer material for embroidery.
Otherwise, the needle may break and cause injuries.
Not using a stabilizer material may result in a poor
finish to your project.
b
It is necessary to move to the beginning of
stitching so press
→ The embroidery frame moves to the beginning of
stitching.
c
Press .
d
Press .
→ The screen changes, and all keys and operation
buttons are locked.
e
Using the presser foot lever, raise the
presser foot.
A-10
, and then press .
f
To bring the bobbin thread above the
fabric, rotate the handwheel
counterclockwise while holding the upper
thread.
g
As shown below, pull the upper thread to
pull the bobbin thread up through the
fabric.
a Upper thread
b Bobbin thread
Memo
• If the bobbin thread cannot be pulled up,
use an awl to create small hole to help pull
bobbin thread to surface.
h
Press to unlock all keys and
buttons.
i
Lower the presser foot.
j
While holding both the upper thread and
the bobbin thread, sew a section of the
pattern.