Table of Contents
Advertisement
OK
The OK button in the Manage Triggers screen saves all changes made. If the [ESC] key is pressed, all
changes are discarded.
Add and Edit Trigger Mapping
•
Tap on Add to add a new trigger map, or tap on Edit to edit an existing trigger map.
Trigger Key
This drop-down list allows you to specify the source of the trigger events, such as the Grip Trigger, Left Scan,
etc., for the trigger module selected.
NOTE
It is possible to map the same source to different modules (trigger consumers) – for
example, to both the Imager and Non-Decoded Scanner. If so, both devices/opera-
tions will occur simultaneously. This is not recommended in most cases, especially
with devices such as Imagers.
It is also possible to map different sources to the same module (trigger consumer).
Add Key
Only existing trigger sources are shown in the Source combo-box. To add a new source to this list, tap on the
Add Key button. A dialog box pops up, allowing you to select the keyboard key to use as a trigger source.
Trigger Press Type
You can enable either an Up/Down or Double Click response to a trigger press. Normally, when a trigger
(keyboard key, etc.) is pressed and released, a "trigger down" event is sent to the "owner" – that is, the applica-
tion receiving the trigger press information – followed by a "trigger up". If Double Click is chosen in this menu,
when the trigger is pressed, released, and then pressed again, a "double-click" event will occur. If a mapping
Draft #6
Settings 4 - 53
Advertisement
Table of Contents
