Setting Baud Rate - Furuno PG500R Operator's Manual

3. INSTALLATION
3.6

Setting Baud Rate

Set the baud rate of external equipment.
The default setting is 4800 bps.
When connecting with the NAVpilot-500, use
the default setting (4800 bps).
1. Disconnect the power connector from the
sensor.
2. Reattach the connector to the sensor
while pressing the [AUTO] key. The
sensor is powered on, and the current
baud rate is shown by the LEDs.
3. Press the [AUTO] key to change the
baud rate as appropriate.
AUTO TRUE
4800
9600
19200
38400
LED and baud rate
If baud rate could not be set, the STATUS
LED blinks quickly. Try again.
The sensor returns to the normal mode if
there is no operation for three seconds.
CALB
STATUS
: On
: Off
13
Relation baud rate and output interval
Baud rate Output interval
25
100
4800
200
1000
25
100
9600
200
1000
25
100
19200
200
1000
25
100
38400
200
1000
Note: When an error message occurs, the above
sentences may be changed
Available sentences
No output
Up to two sentences can
be output.
Up to three sentences can
be output.
HDT or HDM
Up to three sentences can
be output.
Up to two sentences can
be output.
Up to three sentences can
be output.
.