Specifications; Troubleshooting Guide - Heath Zenith SECUR360 9301 Manual

Motion Sensing Range .........................Up to 70 ft. (21 m) [varies with surrounding temperature].
Motion Sensing Angle .........................Up to 180°
Power Requirements .............................120 VAC, 60 Hz
Electrical load – LED...........................16 Watts
Offline Operating Modes .....................TEST and MOTION ACTIVATED
ON-Timer ............................................1, 5, 20 minutes (Night Only)
Test Timer ............................................5 Seconds (Day and Night)
Sensitivity (SENS) ..............................."L", "M", "H"
LED Lumens .......................................1200
LED color temperature ........................5000K
SYMPTOM
The light will not come on.
The light comes on during
the day.
The light comes on for no
apparent reason.
6

SPECIFICATIONS

TROUBLESHOOTING GUIDE

POSSIBLE CAUSE
1. Light switch is turned off.
2. Fuse is blown or circuit breaker is turned off.
3. Daylight turn-off (photocell) is in effect.
4. The circuit wiring is incorrect, if this is a new
installation.
5. The motion sensor is aimed in the wrong
direction.
6. The outside air temperature is close to the
same as a person's body heat.
7. The light has been turned "OFF" using the
app.
1. The motion sensor may be installed in a
relatively dark location.
2. The "Full Brite Time" in the app is set to
"TEST".
1. The motion sensor may be sensing small
animals or automobile traffic.
2. Sensitivity is set too high.
3. The outside temperature is much warmer or
cooler than a person's body heat (summer or
winter).
4. The light fixture is wired through a dimmer
or timer.
To see operational and troubleshooting information and videos,
go to www.hzsupport.com
SOLUTION
1. Turn light switch on.
2. Replace fuse or turn circuit breaker on.
3. Recheck after dark.
4. Verify wiring is correct.
5. Re-aim the motion sensor to cover the
desired area.
6. Increase the sensitivity setting. See Seasonal
Changes on page 5 for more information.
7. Use the app to set the light to "AUTO"
mode.
1. The light fixture is operating normally under
these circumstances.
2. Set the "Full Brite Time" in the app to the 1,
5, or 20 minute setting.
1. Decrease the sensitivity setting or reposition
the motion sensor.
2. Decrease the sensitivity setting.
3. Decrease the sensitivity setting. See Seasonal
Changes on page 5 for more information.
4. Do not use a dimmer or timer to control the
light fixture. Replace the dimmer or timer
with a standard on/off wall switch.
210227-04