Led Indicator; Reset Button; Important Considerations - Heath Zenith SECUR360 9301 Manual

3. Go to the App Store
app or Google Play™ and search for "HeathZenith"
and download the SECUR360 app
enclosed instruction sheet, "Connecting to your new
SECUR360 device", for more details.
4. Once step 4 is complete, open the SECUR360 app and
log into the account. Use the app to set the controls
for the light fixture.

LED Indicator

• RED + Solid: Light is warming up – Stays in this mode
until the light is ready.
• RED + flashing (1 second ON / 1 second OFF): Light
is in wi-fi connection mode.
• BLUE + flashing: Light is connecting to the internet.
• BLUE + (2 Minutes ON): Light is connected to the
internet.
• BLUE : When motion is detected, the LED will be ON
until all motion has stopped for 30 seconds.
For additional information concerning this light or the
SECUR360 app, visit www.heath-zenith.com/Secur360.

IMPORTANT CONSIDERATIONS

AVOID AIMING THE SENSOR AT:
• Below are examples of objects that might produce heat
and may cause the motion sensor to trigger:
• Pools of Water
• Dryer Vents
• Heating Vents
If you suspect that a heat source of this type is triggering
the motion sensor, reduce the sensitivity.
• Areas where pets or traffic may trigger the motion sensor.
• Nearby large, light-colored objects reflecting light may
trigger the shut-off feature. Do not point other lights
at the motion sensor.
210227-04
and search for the "SECUR360"
SM
• Air Conditioners
• Animals
• Automobile Traffic
To see operational and troubleshooting information and videos,
SEASONAL CHANGES:
The motion sensor works by sensing temperature changes
. See the across its field of view. The closer the surrounding tem-
perature is to a person's body heat, the less sensitive the
sensor will appear. The greater the temperature difference,
the more sensitive the sensor will appear. Use the sensitiv-
ity control in the app to adjust the setting as the outside
temperature changes for the different seasons. This is a
normal part of the light sensor's operation.
This light can be reset to the original factory settings either
by using the reset button on the bottom of the sensor or
through the SECUR360 app. Note: After resetting the light,
it may take up to 5 minutes for the light to be removed
from the SECUR360 app.
• Reset Button (see Figure 7) – Use a paper clip to press
the RESET button for 15 seconds to reset the light.
For additional information concerning this light or the
SECUR360 app , visit www.heath-zenith.com/Secur360.
go to www.hzsupport.com

RESET BUTTON

5