Technibel MPAF180R5I Operating Instructions Manual page 6

IMPORTANT
Avoid using radio equipment
such as mobile phone near
(within 1 m) the remote
control receiver. Some radio
equipment may cause
malfunction of the unit.
If the trouble happens,
disconnect power and restart
the air conditioner after a few
minutes.
REMOTE CONTROL receiver
OPERATION button
OPERATION lamp
TIMER lamp
LED CLEAN lamp
NOTE
6
Unit Display and Operation Button
LED CLEAN lamp
TIMER lamp
OPERATION lamp
(ON/OFF) button
This section picks up infrared signals from the remote control unit
(transmitter).
When the remote control cannot be used, pressing this button enables
heating and cooling operation.
Each time this button is pressed, the type of operation conducted is indicated
by the changing color of the OPERATION lamp. Press the button and select
the lamp color that suits your preference for operation.
Cooling operation
(green)
This lamp lights when the system is in the continuous AUTO (red or green),
HEAT (red), DRY (orange), COOL (green) and FAN (green) mode (but no
FAN mode at M of the S/M switch on the remote control unit).
The OPERATION lamp lights up red and orange alternately when the system
is defrosting.
This lamp lights when the system is being controlled by the timer.
This lamp lights during operation in the UV
anti-bacterial mode.
The unit's display lamps are dimmed during operation in the NIGHT
SETBACK mode.
REMOTE CONTROL receiver
Heating operation
(red)
Stop
(lamp off)