Quiet Mode; High Power Mode; Led Clean Mode - Technibel MPAF180R5I Operating Instructions Manual

6. QUIET Mode

7. HIGH POWER Mode

8. LED CLEAN Mode

16
Operation with the Remote Control Unit (continued)
QUIET Mode is used to reduce the fan sound of the indoor unit.
Press the QUIET button.
The mark appears in the display.
To cancel, press QUIET button again.
• In QUIET Mode, the fan rotates at a slower speed than the fan speed
setting.
• If the unit is already operating with a very low airflow, the fan sound may
not change even if the QUIET button is pressed.
HIGH POWER mode can be used to increase the output of the indoor unit for
all operation modes except automatic operation.
Press the HIGH POWER button.
The mark appears in the display.
To cancel, press HIGH POWER button again.
• When the HIGH POWER button is pressed, the unit operates at maximum
output for 30 minutes, regardless of the desired temperature. The fan
speed is 1 step above "High".
• HIGH POWER Mode cannot be used when the operation mode is
Automatic Operation.
• QUIET Mode and HIGH POWER Mode cannot be used at the same time.
NOTE • When set to High fan speed during heating operation, the
fan runs at High fan speed even though the
displayed.
• Depending on the operating conditions, the fan speed may
be increased by a small amount only.
In LED CLEAN mode, a UV antibacterial unit (including a LED CLEAN lamp and anti-bacterial filter)
is used to remove the bacteria from air blown from the air conditioner..
Press the LED CLEAN button.
The mark appears in the display.
To cancel, press LED CLEAN button again.
• When this button is pressed, the UV antibacterial unit operates for 30minutes: don't open the front panel.
• Pressing MODE button cancels LED CLEAN mode
• The LED CLEAN lamp may reflect inside the airconditioner and be visible: it's not a malfunction.
mark is