pro user APB120 Manual page 5

13. Splice the red wire using the supplied in-line wire connectors to the reverse light's
positive (+) wire. Use a set of slip joint pliers to squeeze the TAP and insure good
connection.
14. Next splice the black wire of the transmitter box power cable to the reverse light's
negative (-) wire or ground.
15. Replace the reverse light bulb, and then re-install the light socket. Secure all the
wires with cable ties or electrical tape.
16. Re-attach the negative battery cable to the battery.
Rear View Mirror Installation
When mounting the mirror, please double check the width of your car's rear view mirror≤
80mm to avoid cannot be installed.
1. Place the spring loaded top clips underneath the car's existing rear view mirror.
2. Press down the mirror extend to the bottom clips, then tilt the mirror towards the
existing rear view mirror.
3. Left the spring loaded clips close around the mirror. Adjust the Rear View Mirror for
the best rear view.
5