Regarding The Indicator Lamps - ViewSonic PJ1165 User Manual

Regarding The Indicator Lamps

Lighting and blinking of the STANDBY/ON indicator, the LAMP indicator and the TEMP
indicator have the meanings as described in the table below. Please respond in according
with the instructions within the table. If the same indication is displayed after the treatment,
or if an indication other than the following is displayed, please contact your dealer or service
company.
NOTE
• When the interior portion has become overheated, for safety purposes, the power
source is automatically turned off, and the indicator lamps may also be turned off. In
such a case, press the [O] (Off) side of the main power switch, and wait at least
45minutes. After the projector has sufficiently cooled down, please make confirmation of
the attachment state of the lamp and lamp cover, and then turn the power on again.
STANDBY/ LAMP
ON indicator indicator
Lighting in
Turned off Turned off The projector is in a standby state.
Orange
Blinking in
Turned off Turned off The projector is warming up.
Green
Lighting in
Turned off Turned off The projector is in an on state.
Green
Blinking in
Turned off Turned off The projector is cooling down.
Orange
Blinking in (discretion-
Red ary)
Lighting in Lighting in
Red Red
TEMP
indicator
Please refer to the section "Power On/Off".
Please wait.
Ordinary operations may be performed.
Please wait.
The projector is cooling down. A certain error
has been detected.
(discretion-
Please wait until the STANDBY/ON indicator fin-
ary)
ishes blink, and then perform the proper response
measure using the item descriptions below as ref-
erence.
The lamp does not light, and there is a
possibility that interior portion has become
heated.
Please turn the power off, and allow the unit to
cool down at least 20 minutes. After the projector
has sufficiently cooled down, please make
confirmation of the following items, and then turn
Turned off
the power on again.
• Is there blockage of the air passage aperture?
• Is the air filter dirty?
• Does the peripheral temperature exceed 35°C?
If the same indication is displayed after the
treatment, please change the lamp by referring to
the section "Lamp".
(This table is continued to the following page.)
Description
ViewSonic PJ1165 42