Option Menu - ViewSonic PJ1165 User Manual

OPTION Menu

With the OPTION menu, the items shown in the table below can
be performed. Perform each operation in accordance with the
instructions in the table below.
Item
VOLUME
SPEAKER
IR REMOTE
IR REMOTE ID
LAMP TIME
FILTER TIME
Adjust the volume using the
High Low
Select the TURN ON or the TURN OFF using the
TURN ON TURN OFF
When the TURN ON is selected, the built-in speaker works.
Select a remote sensor using the
switch it using the ENTER button (2).:
(1) FRONT TOP
A sensor cannot be turned off when the other two are
memo
off. Always at least one sensor is on.
Select a number as an ID number for remote control using the
buttons.:
ALL 1 2
The projector is controlled by the remote control whose ID CHANGE
switch is set into the position of the same number as this number.
When the ALL is selected, the projector is controlled by a remote
control irrespective of the position of the ID CHANGE switch.
Please refer to the section "Using The Remote ID Feature".
memo
Pressing the RESET button for about 3 seconds displays the LAMP
TIME menu.
Select the RESET using
RESET CANCEL
Selecting the RESET resets the count of the lamp timer to 0.
Perform this function only when you have replaced the lamp. The
memo
lamp timer counts the used time of the current lamp, to display the
messages about the lamp. Incorrect performing causes incorrect
operation of the messages.
About replacing the lamp, please refer to the section"Lamp".
memo
Pressing the RESET button for about 3 seconds displays the FILTER
TIME menu.
Select the RESET using
RESET CANCEL
Selecting the RESET resets the count of the lamp timer to 0.
Perform this function only when you have cleaned or replaced the
memo
air filter. The filter timer counts the used time of the air filter after
cleaning or replacement, to display the messages about the air filter.
Incorrect performing causes incorrect operation of the messages.
About caring for the air filter, please refer to the section "Air Filter".
memo
Description
/ buttons.:
/
REAR (2) (Off)
3
button to reset the timer.:
button to reset the timer.:
(This table is continued to the following page.)
/ buttons.:
button (1), then
(On)
ViewSonic PJ1165
/
33