Table of Contents
Advertisement
2)
Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3)
Press as to select [AUTO POWER SAVE].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
5)
Press as to select [AMBIENT LIGHT DETECTION] or [NO SIGNAL LIGHTS-OUT].
[AMBIENT LIGHT
DETECTION]
[NO SIGNAL LIGHTS-OUT]
6)
Press qw to switch the item.
f The items will switch each time you press the button.
[AMBIENT LIGHT
DETECTION]
[NO SIGNAL LIGHTS-OUT]
Note
f [AMBIENT LIGHT DETECTION] and [NO SIGNAL LIGHTS-OUT] cannot be set when [AUTO POWER SAVE] is set to [OFF].
f The power indicator <ON (G)/STANDBY (R)> will blink slowly in green while the no signal lights-out function is operating and the light source
is turned off.
f When [NO SIGNAL LIGHTS-OUT] is set to anything other than [DISABLE], the conditions to turn on the light source again from the condition
that the light source was turned off by this function are as follows.
g When the signal has been input
g When on-screen display such as menu screen (OSD) or input guide, a test pattern, or a warning message is displayed
g When the power <v/b> button is pressed
g When the operation to disable the shutter function (shutter: open) is performed, such as pressing the <SHUTTER> button
g When the operating environment temperature is around 0 °C (32 °F) and the light source is forced to turn on due to warm-up
f The luminance may not be detected correctly when an object is placed on top of the projector, blocking the luminance sensor. In such a
case, it may not operate properly even if [AMBIENT LIGHT DETECTION] is set to [ON].
Setting [NO SIGNAL SHUT-OFF]
This is a function to automatically set the power of the projector to standby mode when there is no input signal for
specific period. The time before switching to standby can be set.
1)
Press as to select [ECO MANAGEMENT].
2)
Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3)
Press as to select [NO SIGNAL SHUT-OFF].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[DISABLE]
[10MIN.] - [90MIN.]
Setting [STANDBY MODE]
Set the power consumption during standby and whether to enable the [QUICK STARTUP] function.
1)
Press as to select [ECO MANAGEMENT].
Chapter 4 Settings — [PROJECTOR SETUP] menu
Disables the auto power save setting.
Enables the auto power save setting.
Adjusts the power of the light source in accordance with the brightness of the installed location.
Automatically turns off the light source of the projector when there is no input signal for specific
period.
[OFF]
[ON]
[DISABLE]
[10SEC.] - [5MIN.]
Disables the no signal shut-off function.
Sets the time in increments of 10 minutes.
Disables the ambient light detection function.
Enables the ambient light detection function.
Disables the no signal lights-out function.
Turns off the light source when there is no input signal for the preset
period.
Select [10SEC.], [20SEC.], [30SEC.], [1MIN.], [2MIN.], [3MIN.], or
[5MIN.].
ENGLISH - 97
Advertisement
Table of Contents
