Table of Contents
Advertisement
Setting [EDID MODE] in [COMPUTER IN/OUT] (COMPUTER1 input/COMPUTER2 input)
1)
Press as to select [COMPUTER IN/OUT].
2)
Press the <ENTER> button.
f The [COMPUTER IN/OUT] screen is displayed.
3)
Press as to select [EDID MODE] of [COMPUTER1] or [COMPUTER2].
4)
Press the <ENTER> button.
f The [EDID MODE] screen is displayed.
5)
Press qw to switch the item.
f The items will switch each time you press the button.
[DEFAULT]
[SCREEN FIT]
[USER]
f Proceed to Step 10) when [DEFAULT] or [SCREEN FIT] is selected.
6)
Press the <ENTER> button.
f The [RESOLUTION] screen is displayed.
7)
Press asqw to select [RESOLUTION].
f Select [1024x768p], [1280x720p], [1280x768p], [1280x800p], [1280x1024p], [1366x768p], [1400x1050p],
[1440x900p], [1600x900p], [1600x1200p], [1680x1050p], [1920x1080p], [1920x1080i], or [1920x1200p].
8)
Press the <ENTER> button.
f The [VERTICAL SCAN FREQUENCY] screen is displayed.
9)
Press qw to select [VERTICAL SCAN FREQUENCY].
f Select [60Hz], [50Hz], [30Hz], [25Hz], or [24Hz] when [1920x1080p] is selected for [RESOLUTION].
f Select [60Hz], [50Hz], or [48Hz] when [1920x1080i] is selected for [RESOLUTION].
f Select [60Hz] or [50Hz] when anything other than following is selected for [RESOLUTION].
g [1920x1080p], [1920x1080i]
10) Press the <ENTER> button.
f The confirmation screen is displayed.
11) Press qw to select [OK], and press the <ENTER> button.
Note
f Settings in [RESOLUTION] and [VERTICAL SCAN FREQUENCY] are displayed in the [COMPUTER IN/OUT] screen.
f Setting of the resolution and the vertical scanning frequency may be necessary on the computer or video device in use.
f The computer, video device, or projector in use may require the power to be turned off and on again after setting.
f The output with the set resolution or vertical scanning frequency may not be possible depending on the computer or video device in use.
f [EDID MODE] in [COMPUTER2] cannot be set when [COMPUTER2 SELECT] is set to [COMPUTER1 OUT].
Setting [COMPUTER2 SELECT] in [COMPUTER IN/OUT] (COMPUTER2 input/COMPUTER1
output)
1)
Press as to select [COMPUTER IN/OUT].
2)
Press the <ENTER> button.
f The [COMPUTER IN/OUT] screen is displayed.
3)
Press as to select [COMPUTER2 SELECT].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[COMPUTER2 IN]
[COMPUTER1 OUT]
Chapter 4 Settings — [DISPLAY OPTION] menu
Standard setting.
Changes the EDID data according to the [SCREEN FORMAT] setting.
Sets the [RESOLUTION] and [VERTICAL SCAN FREQUENCY] items as EDID.
Select this item when using the <COMPUTER 2 IN/1 OUT> terminal as the COMPUTER2 input.
Select this item when the analog RGB signal or YC
terminal is output from the <COMPUTER 2 IN/1 OUT> terminal.
C
/YP
P
signal input to the <COMPUTER 1 IN>
B
R
B
R
ENGLISH - 83
Advertisement
Table of Contents
