Table of Contents
Advertisement
16 Security slot
This security slot is compatible with the Kensington security
cables.
17 <MAIN POWER> switch
Turns on/off the main power.
Attention
f Do not block the ventilation ports (intake and exhaust) of the projector.
r Control panel
1
Power <v/b> button
Sets the projector to the state where the projector is turned
off (standby mode) when the <MAIN POWER> switch on the
projector is set to <ON> and in projection mode.
Sets the projector to projection mode when the power is
switched off (standby mode).
r Connecting terminals
1
<VIDEO IN> terminal
This is a terminal to input video signal.
2
<COMPUTER 1 IN> terminal
This is a terminal to input the RGB signal, YC
or Y/C signal.
3
<COMPUTER 2 IN/1 OUT> terminal
This is a terminal to input the RGB signal or YC
signal.
Also, the RGB signal or YC
<COMPUTER 1 IN> terminal can be output to an external
device. Video signal is output when the input is switched to
COMPUTER1.
4
<DVI-D IN> terminal
This is a terminal to input the DVI-D signal.
5
<HDMI 1 IN> terminal/<HDMI 2 IN> terminal
This is a terminal to input the HDMI signal.
6
<DIGITAL LINK/LAN> terminal
This is a terminal to connect a device that transmits video
signal or audio signal via the LAN terminal. Also, this is the LAN
terminal to connect to the network.
Attention
f When a LAN cable is directly connected to the projector, the network connection must be made indoors.
Chapter 1 Preparation — About your projector
1
2
1
2
3
8
9
C
/YP
P
signal,
B
R
B
R
C
/YP
P
B
R
B
R
C
/YP
P
signal input to the
B
R
B
R
18 <AC IN> terminal
Connect the supplied power cord.
19 Burglar hook port
Attaches a burglar prevention cable, etc.
3
2
<MENU> button/<RETURN> button/<ENTER> button/
asqw buttons
Used to navigate through the menu screen.
Also used to enter a password in the [SECURITY] menu or
enter characters.
3
<INPUT SELECT> button
Switches the input signal to project. (x page 47)
4
5
10
11
12
7
<LAN> terminal
This is the LAN terminal to connect to the network.
8
<AUDIO IN 1> terminal
This is a terminal to input audio signal. There are right input
<R> and left input <L>.
9
<SERIAL IN> terminal
This is the RS-232C compatible terminal to externally control
the projector by connecting a computer.
10 <AUDIO IN 2> terminal/<AUDIO IN 3> terminal
This is a terminal to input audio.
11 <VARIABLE AUDIO OUT> terminal
This is a terminal to output the audio signal input to the
projector.
12 <DC OUT> terminal
This is the USB terminal dedicated for power supply. (DC5 V,
maximum 900 mA)
This can be used when a power is needed to be supplied to a
wireless display adaptor, etc.
6
7
ENGLISH - 27
Advertisement
Table of Contents
