Yamaha TT600RE 2004 Service Manual page 146

5
4
6
2
b
a
3. Install:
•
Brake pads
•
Pad support
Installation procedure:
•
Connect the hose (1) firmly to the caliper
bleeder screw (2). Place the other end of the
hose in an open container.
•
Loosen the caliper bleeder screw and push
the piston into the caliper with your finger.
•
Retighten the bleeder screw (2).
Caliper bleeder screw:
•
Install the (new) brake pads and (new) pad
support.
•
Install the caliper (3) and the pad pin (4).
•
Install the (new) pin retainer (5)
•
Install the caliper protector (6).
Caliper protector bolt:
3
4. Check:
•
Brake fluid level
Refer to "BRAKE FLUID INSPECTION"
section in Chapter 3.
(a) Minimum level mark "MIN"
(b) Maximum level mark "MAX"
5. Check:
•
Brake pedal operation
Pedal soft and spongy
brake circuit.
Refer to "AIR BLEEDING (HYDRAULIC
BRAKE SYSTEM)" section in Chapter 3.
4-31
CHAS
REAR BRAKE
14 Nm (1.4 mkg)
10 Nm (1.0 mkg)
Bleed air from