Safety Cable Installation - Monte Carlo Fan Company 3OWR60D Series Owner's Manual And Installation Manual

7
Tab
Install ball end of downrod into mounting
bracket opening. Align (engage) slot on
ball with tab on mounting bracket.
Warning: Failure to align slot on ball with
tab may result in serious injury.
Important: If using the angle mount,
make sure open end of mounting bracket
is installed facing the higher point of the
ceiling and make sure the ceiling angle is
not steeper than 30º.
10
Grounded
wires
Receiver
After making the wire connections, the wires
should be spread apart with the grounded
conductor and the equipment-grounding
conductor on one side of the outlet box and
ungrounded conductor on the other side of
the outlet box. The splices after being made
should be turned upward and pushed carefully
up into the outlet box.
© 2016 Monte Carlo Fan Company
8
Lag screw
Safety cable
Slot
Washer
Lock washer
For Canadian installation and for USA fan
and light kit combinations over 35 lbs, in
both flush and downrod modes the safety
cable must be installed into the house
structure beams using 3" lag screws,
washers and lock washers provided.
Make sure that when the safety cable is
fully extended the lead wires are longer
than the cable and no stress is placed on
the lead wires.
Note
: If Installing The Secondary Support
Safety Cable in the U.S., Do Not Remove
Knockouts In The Outlet Box.
11
Ungrounded
Stud
wires
Lift Canopy allowing the 2 studs to protrude
through the canopy.
Install knurled nuts as shown. Tighten the
knurled nuts securely. The canopy should
adjust for any irregularity in the ceiling or
Outlet box.
Make sure the studs protruding from the
bottom of the Mounting bracket are installed
with threads all the way through the bracket.

SAFETY CABLE INSTALLATION

4
9
Black
(Live)
Wall switch
White
(Neutral)
Ground/Green
Make wiring connections using wire
connectors provided as indicated above.
White from fan to White from remote marked
N. Black from fan to Black from remote
marked L. Blue from fan to Blue from remote
marked FOR Bottom Light. Orange from fan to
orange from remote marked For Upper Light.
White from house to White from remote
marked AC IN N. Black from house to Black
from remote marked AC IN L. Connect all
green grounded wires to Grounded wire from
House. Make sure that no filaments are
outside of the wire connectors.
Insert the remote receiver into mounting
bracket. Refer to page 7 for receiver
setting.
12
Insert blade into the slot on flywheel.
Install blade with screws and fiber
washers provided, aligning each of the
holes as shown and tighten all screws
securely. Repeat this process for
remaining blades.
White Black
Blue
Orange
Receiver
Black
White
Blade
11/2016