Table of Contents
Advertisement
Asystems Virtual Webcam Emulation Setup Guide
Webcam Emulation
In an age where everyday people are allowed to host their own channels talking about anything and everything of
their interests by streaming videos live, a virtual webcam emulation has become an essential feature of compact video
switchers. With Asystems' diverse video switchers, we grant user the ability to stream and broadcast video live via RJ-45
connector. When webcam emulation is established, user is able to use all streaming programs and services to stream
and broadcast live recording through the internet with ease.
Please refer to the following steps to begin webcam emulation setup procedures.
1.
Connect the computer to the RJ45 Video
Streaming connector in the back of the panel.
2.
Turn off the private firewall & antivirus softwar
Open the Control Panel on your computer
●
Then open the Windows Firewall
●
Select Turn Windows Firewall on or off
●
Turn off the firewall within the Private
●
network settings while leaving the Public
network settings turned on
Turn off your antivirus software for
●
installation to prevent installation being
blocked.
Alternatively, you can add the iNETCAM.
●
exe as a trusted source and NETCAM.X.86.
AX and NETCAM.X.64.AX to the exception
list.
3.
Set up virtual webcam's IP address by automatic
detection method (DHCP).
4.
Auto IP address
Connect both video switcher's streaming
●
output and broadcasting PC's LAN to a
DHCP capable IP network router.
(The Dynamic Host Configuration Protocol
(DHCP) is a standardized network protocol
used on Internet Protocol (IP) networks for
dynamically distributing network configuration
parameters, such as IP addresses for
interfaces and services.)
In the SYSTEM STATUS menu of the video
●
switcher, make sure the DHCP is set to ON
(Default at ON), when done so correctly, the
IP address will be displayed.
5.
Download the NETCAM pack on Asystems'
website under the Download page (http://www.
asystems-sys.com/en/help/downloads/).
First unzip the file and clic "Yes" to install
●
the iNETCAM.exe executable file.
The InstallShield Wizard window will
●
pop up, click "Next" to begin the CODECS
installation.
You will then be asked to enter the "User
●
Name" and "Organization".
59
AV800HD
English
Advertisement
Table of Contents
