Pip Operation Mode (Operating Mode 2) - A SYSTEMS AV800HD User Manual

AV800HD
Program Transition Control
Program Transition Control is used to swap contents between PVW and PGM channels. There are three ways of performing
the transition, Auto transition and manual transition, giving you the total control and creative freedom to transition between
input sources.
1. Auto: Press "AUTO" button to perform a transition with selected wipe pattern and transition time.
2. Manual: Use transition T-Bar to perform a manual transition with selected wipe pattern.
3. Cut: Press "CUT" button to perform an instant transition.

PIP Operation Mode (Operating Mode 2)

Enable PIP preview will switch the top panel controls to PIP operating mode.
PIP Buttons 1-4
Scale/Size Joystick
PGM
PIP Preview (PVW Screen)
CH1 CH2
CH1 CH2
CH5 CH6
CH5 CH6
PIN Multiview Screen
Note: Double click on PIP button (LED starts to flash) then press ENTER button to revert PIP size and position
back to original startup condition of PIP button.
English
PGM
PGM
CH3 CH4
CH3 CH4
CH7/A CH8/A
CH7/A CH8/A
24
Press PIP 1-4 to determine starting location;
these buttons also serve as 4 PIP preset memory
locations.
Scale/Size Joystick will switch to PIP Mode (PIP/
KEY LED lit); press SEL button to toggle joystick
controls between PIP and Camera.
Multiview screen will switch to PIP mode.