A SYSTEMS AV800HD User Manual page 25

Wipe Patterns
By selecting a wipe pattern will switch the operating mode to Transition Operation Mode. By default, after system power up,
it will automatically assumes default to Transition Operation Mode.
Wipe Pattern Buttons
Note: See Setup Menu for more wipe patterns setup and selection.
Transition Time/Frames Adjustment
Transition time defines the time interval when AUTO transition is used. Default transition format is in Time Mode or the last
mode used in previous shutdown; other formats can be selected from the Setup Menu.
Transition in time
Transition in frames
Transition in time-frame
Note: The number of frames per second is determined by PGM Output Video System and Frame Rate in the Setup
Menu (i.e. NTSC 30P will have 30 frames per second).
1. MIX is the default wipe pattern upon first power
up or system reset, otherwise, the last wipe pattern
used prior to shut down will be the default wipe
pattern for the next power up.
If system is shutdown prematurely or unexpectedly,
MIX will be the default pattern.
2. Select one of wipe pattern buttons on the top
panel to enable the new wipe pattern or switch
back transition mode.
1. Transition Time Adjustment: When in Time
Adjustment Mode, the LED is displayed in second
format with a decimal point after the 1st MSB.
Use TIME/FRAME knob to adjust. (Range: 0.00 to
9.99 seconds)
2. Transition Frames Adjustment: When in Frame
Transition Mode, the LED is displayed in frame
format, with no decimal points. Use TIME/FRAME
knob to adjust. (Range: 000 to 999 frames)
3. Transition Time-Frame Adjustment: When in
Time-Frame Transition Mode, the LED is displayed
in Time-Frame format with two decimal points.
MSB is time in second format (0 to 9 seconds);
the two LSB are frame. Use the TIME/FRAME
knob to adjust. (Clockwise to adjust the frame and
counterclockwise to adjust the time).
23
AV800HD
English