Table of Contents
Advertisement
2. Remove power head and place in upside down position. Follow instructions to
filter, see page 10.
3. Carefully slide foam sleeve filter down over the filter cage making sure the whole cage is covered.
(fig.2 & 3)
4. Replace the power head on to the container.
Cleaning Foam Sleeve Filter
1. With the removed power head in the upside down position, carefully remove foam sleeve filter. (fig.4)
2. Use a mild soap and water solution to wash foam sleeve filter and rinse with clean water. (fig.5)
3. Allow filter to air dry before installing and using again.
INSTALLING THE DUST COLLECTION BAG
Instructions For Dust Bag Installation - FOR DRY PICK-UP ONLY.
1. Slide the cardboard collar opening firmly onto the vacuum port deflector until it stops against the
deflector wall.
2. Position the bag so that it is distributed around the inside of the tank.
3. Replace and secure the power head onto the tank.
4. FOR DRY PICK-UP ONLY.
Symptom
WARNING!
TO REDUCE THE RISK OF ELECTRIC SHOCK-UNPLUG BEFORE TROUBLESHOOTING
Vacuum will not operate
Dust comes out from motor cover.
Reduced efficiency and
motor/speed vibration.
TROUBLESHOOTING
Possible Causes
1) No power supply.
2) Faulty power cord.
3) Container full.
1) The reusable cloth filter is missing
or damaged.
1) There is a blockage in the nozzle,
hose, or the vacuum inlets. Or the
reusable cloth filter is blocked by fine
dust.
Corrective Action
1) Check power supply – cord,
breakers, fuses.
2) Unplug and check the power
cord. If damaged, have it repaired
by a professional.
3) Empty container.
1) Attach or replace the reusable
cloth filter.
1) Check nozzle, hose and inlets
for blockage. Take off the filter and
clean it. Or install new filter.
11
remove reusable cloth
Advertisement
Table of Contents
