Dry Vacuum Operation - Vacmaster VQ407S-A Operator's Manual

Wet/dry vacuums
Table of Contents

Advertisement

POLARIZED PLUG
To reduce the risk of electrical shock, this appliance has a double polarized plug (one with the blade wider
than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not
change the plug in any way. Double insulation
cord and grounded power supply system.
DRY-VACUUM OPERATION
DRY VACUUMING
BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION, ENTITLED 'SAFETY
WARNING:
INSTRUCTIONS & WARNINGS'. DO NOT VACUUM IN AREAS WITH FLAMMABLE GASES, VAPORS,
OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT
LIMITED TO; LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-BASE PAINTS, GASOLINE,
ALCOHOL OR AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO;
COAL, MAGNESIUM, GRAIN OR GUN POWDER. TO REDUCE THE RISK OF HEALTH HAZARDS
FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIALS.
CAUTION:
Do not vacuum drywall dust, fireplace soot or ash with
dust which will not be captured by the filter and may cause damage to motor. When vacuuming fine dust
use a fine dust filter (sold separately).
WARNING
: DO NOT PLUG IN POWER CORD TO POWER OUTLET. MAKE SURE PLUG IS
DISCONNECTED BEFORE CHANGING AND CLEANING FILTERS.
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Make sure the filter is completely covering the filter cage against the power head. (fig.2 & 3 ) (Your
Wet/Dry Vac comes with the reusable cloth filter pre-installed, if not, see page 10 for installation
instructions.)
3. Optional, for improved dust filtering, fit collection bag onto the tank. Fit the flange onto the inlet stub,
taking care not to damage the bag. (fig.4)
4. Place the power head back on the container, and secure it in place using the latches. (fig.5)
OPERATING INSTRUCTIONS: DRY VACUUMING
5. Insert the locking end of the hose into the vacuum port and screw in place. Push the required attachment
onto the free end of the hose or extension. (fig.6)
eliminates the need for the three wire grounded power
standard cloth or sponge filter. This is a very fine
7

Advertisement

Table of Contents
loading

Table of Contents