Technibel Climatisation CAFM1V Installation Instructions Manual page 53

06-062 Mini ECO-i II for Technibel
(5) Before suspending the indoor unit, remove the 2
or 3 screws on the latch of the air-intake grilles,
open the grilles, and remove them by pushing the
claws of the hinges as shown in Fig. 3-88a. Then
remove both side panels sliding them along the
unit toward the front after removing the 2 attach-
ment screws. (Fig. 3-88b)
(6) Carry out the preparation for suspending the
indoor unit. The suspension method varies
depending on whether there is a suspended ceil-
ing or not. (Figs. 3-89a and 3-89b)
(7) Suspend the indoor unit as follows:
a) Mount 1 washer and 2 hexagonal nuts on each
suspension bolt as shown in Fig. 3-89c.
2/8/06 4:32 PM Page 53
53
Pull out the
air-intake grille
pushing claws
of the hinges
Screw
Latch
Air-intake grille
Fig. 3-88a
Slide toward
front side
Side panel
Fig. 3-88b
Unit
Fixture
Fig. 3-89a
Unit
Fig. 3-89b
Washer
(supplied)
Suspension bolt
Fig. 3-89c
Hinge
SPAFM
Suspension bolt
(field supply)
Ceiling surface
Washer (supplied)
Double nut
(field supply)
Suspension bolt
(field supply)
Washer (field supply)
Washer (supplied)
Double nut
(field supply)
Ceiling
surface
Nut
(field supply)