Supplying Power From A Poe+ Power Supply - Panasonic Lumix DC-BS1H Operating Instructions Manual

● Do not use any other AC adaptors except the supplied one. This may cause malfunction.
● Do not use any other AC cables/AC mains leads except the supplied one. This may cause malfunction.
● Turn off the camera before connecting or disconnecting the power plug.
● Do not leave any metal items (such as clips) near the contact areas of the power plug. Otherwise, a fire and/or electric
shocks may be caused by short-circuiting or the resulting heat generated.
● Do not use the AC adaptor and AC cable/AC mains lead with other devices. This may cause malfunction.
● If there is a power outage or other problems with the electrical outlet, please reconnect the power plug.
● Power is being consumed even if the camera is turned off. When the camera will not be used for a long time, remove the
power plug from the electrical outlet in order to save power.

Supplying power from a PoE+ power supply

This camera is PoE+ (IEEE 802.3at compliant) compatible. Connect the camera to a PoE+ compatible switching hub or PoE+
compatible injector to supply power (power supply).
PoE+ compatible LAN cable (commercially available)
A
PoE+ compatible switching hub (commercially available)
B
Power plug
C
1
Connect the [LAN] terminal of the camera and the PoE+ compatible switching hub
with a PoE+ compatible LAN cable.
● For the cable that connects to the LAN terminal, use the one below.
– LAN cable (STP (Shielded Twisted Pair), category 5e or above, maximum 100 m (328 feet))
Use a PoE+ (IEEE 802.3at compliant) compatible switching hub or power supplying device. *
●
(Not all PoE+ (IEEE 802.3at compliant) compatible device operations are guaranteed.)
* Make sure it complies with the safety standards IEC 60950-1 or IEC 62368-1. If you are uncertain on whether or not it
1
complies with the safety standards, please contact the manufacturer of the switching hub or power supplying device.
● You cannot use a PoE (IEEE 802.3af compliant) switching hub or power supplying device.
● After turning the camera on, when the device or cable used is determined PoE+ incompatible by the camera, the camera
automatically turns off. (Determining may take approximately 3 minutes.)
● The camera's Wi-Fi connection, Bluetooth connection, and USB connection cannot be used while supplying power with
PoE+.
If you connect a PC to a switching hub that supplies power to the camera with PoE+ via a LAN cable, you can remotely
●
control the camera with the software "LUMIX Tether" while supplying power to the camera with PoE+.
2. Getting Started - Power supply
A
- 17 - - 17 -
C
B
1