Power Supply - Panasonic PalmCam PV-DC2090 Operating Instructions Manual

Power Supply
I floP, 1i IIili I | i"_+__ I,P_ i i i t=.l t,_"_l l=.]| [=._
Bottom View
While pressing the Lock button, slide
the Battery Compartment lid in the
direction of the arrow and swing it open.
2
Install four Alkaline Batteries.
• Be sure to use Alkaline Batteries.
Never use manganese batteries.
• Make sure that the positive (+) and (-)
ends of the batteries are facing the
correct direction.
Swing the Battery Compartment lid
down and slide it shut.
WARNING! o not dispose of in fire, put in backwards, disassemble, or short circuit;
otherwise battery may leak or burst, causing possible personal injury.
)
Safety precautions:
• Do not mix old and new batteries,
• Do not mix alkaline with manganese
batteries.
• Do not get the AA alkaline batteries near,
or dispose of in fire.
• Do not directly connect (short circuit) the
positive (+) and negative (-) terminals.
• Never attempt to disassemble or reas-
semble the Battery.
• Do not drop or jar the Battery.
Note:
• Instead of the supplied Alkaline batteries,
you can also use AA type Ni-Cd (high
density type) or nickel-hydride batteries
available on the market.
• If you are not going to use the Digital
Camera for an extended period Of time,
remove the batteries from the Digital
Camera.
When using the supplied Panasonic
alkaline batteries, you will have a maximum
of about 160 images* (at an ambient
temperature of 25°C).
• Conditions :
• Using the Panasonic Alkaline batteries.
• Capturing an image every 30 seconds.
• Using Flash once for every other capture.
• Recording mode is Fine.
14
• i[,,] ll: i--,,.--1 [...-I _.li[_:.m_, i I•
!t :liIi l-I'Jw, lll'il i l<1€ Ill