Table of Contents
Advertisement
4 In the IP address text box, enter an IP address for the device.
5 If required, in the Gateway text box, enter a gateway address for the device.
6 If required, in the Network prefix length text box, enter a the prefix length.
7 If required, in the DNS 1 text box, enter a Domain Name System (DNS) address.
8 If required, in the DNS 2 text box, enter a DNS address.
9 Touch Connect.
10 Touch
.
Advanced Wi-Fi Settings
Note: Advanced Wi-Fi settings are for the device not for a specific wireless network.
Use the Advanced settings to configure additional Wi-Fi settings. From the Wi-Fi screen, touch
view the advanced settings.
•
General
•
Network notification - When enabled, notifies the user when an open network is available.
•
Keep Wi-Fi on during sleep - Opens a menu to set whether and when the Wi-Fi radio turns off.
•
Always (increases data usage) - The radio stays on when the device enters suspend mode.
•
Only when plugged in - The radio stays on while the device is connected to external power.
•
Never - The radio turns off when the device enters suspend mode (default).
•
MAC address - Displays the Media Access Control (MAC) address of the device when connecting to Wi-Fi
networks.
•
IP address - Displays the IP address of the device when connecting to Wi-Fi networks.
•
Regulatory
•
Country selection - Displays the acquired country code if 802.11d is enabled else it displays the currently
selected country code.
•
Region code - Displays the current region code.
•
About
•
Version - Displays the current Fusion information.
WLAN Configuration
Use the WLAN Configuration settings to configure additional WLAN settings. From the Wi-Fi screen, touch
WLAN Configuration to view the settings.
•
Country Override - Check to disable 802.11d. Select the country of operation from the menu.
•
Rate Selection
•
Auto Mode (a/b/g/n) - Use all data rates available (default).
•
11a/b/g Only - Use only 802.11 a/b/g.
•
11n mode Only - Use only 802.11n.
•
Band Selection
•
Auto (2.4GHz and 5GHz) - Use both the 2.4 GHz and 5 GHz bands (default).
•
2.4Ghz Only - Use only the 2.4 GHz band.
•
5Ghz Only - Use only the 5 GHz band.
•
Enable Power Saving - When enabled, the WLAN radio goes into sleep mode when there is no WLAN activity.
MN000xxxA01 | February 2014 |
Wireless | 111
> Advanced to
>
Send Feedback
Advertisement
Table of Contents
Troubleshooting
